4' x 6' Chicken Coop - Fits 6-8 Chickens - Amish Craftsmanship

This 4' x 6' chicken coop houses 6 to 8 chickens for fresh eggs daily! If you're looking for a medium-sized chicken coop that is built to stand the test of time, this is the one! The EZ-fit Chicken Coop is delivered partially assembled with Smartside siding primed and ready to paint. Coop can be assembled quickly with basic skills (scroll to the bottom of this page for instructions). Enjoy free-range, fresh eggs with your own chicken coop.

The EZ-FIT Chicken Coop is the ultimate solution for raising healthy chickens and enjoying fresh, free-range eggs every day. With its sturdy Amish-crafted design, predator-resistant features, and optional mobility, this coop is built for convenience and durability. Made in the USA.

Standard Features:

Outside egg collection box

Chicken door & ramp

Inside roost

Predator-resistant wire mesh

Man Door

Windows

25-Year shingles (dark brown color)

Easily move your coop across your pasture or backyard with our optional EZ-skid Runners (shown). Simply hitch up your garden tractor and you’re ready to go! Runners are zinc galvanized to prevent rusting.

Please note: Everything is included except for the paint. The coop comes primed and ready for paint.

USUALLY SHIPS IN 1-2 WEEKS.  FREE SHIPPING IN THE CONTINENTAL USA!

Assembly Instructions:

PLEASE NOTE: The floor is already assembled and is at the very bottom of the package.

ALSO NOTE: If you purchased the EZ‐Skid runners, install these before you begin assembly of your coop.

Use the provided heavy duty screws to fasten EZ‐Skid runner brackets to the 4x4" skids.

Step 1. Begin by fastening the rear wall. Wall is same length as the floor and should be flush at both ends.

Fasten from outside of siding into floor joists with nails and from bottom plate of wall down into floor joists with 3" screws.

Step 2. Fasten the front wall in the same way.

Step 3. Place the right sidewall into position and fasten to front and rear walls and to the floor.

Step 4. Place the left sidewall into position and fasten.

Step 5. Place rafters 24" on center and fasten from bottom of plywood top‐plate up into the rafter.

Step 6. Keep roof sheathing flush with the peak of the rafters and fasten both front and rear roof sheathing.

Step 7. Gable end ("Barge") trim is installed at the factory.

NOTE: There will be a gap between roof sheathing and barge…this will get covered up by the drip edge and shingles.

Step 8. Fasten front and rear facia trim into the heel of rafter.

Step 9. Slide nesting box into place and fasten from inside.

Step 10. Chicken roost is a 2x3"x the length of building. Place the roost on edge and fasten on both ends.

Chicken roost should be approx 18‐24" off the floor.

Step 11. Install alum. dripedge around the perimeter of the roof.Install bottom row of shingles with tabs pointing upwards as an underlayment row.

Step 12. Continue by installing shingles from right to left. Shingle tabs are 12" wide. Offset each row 6".

Step 13. Once both sides are shingled, cut remaining shingles into 12" tabs to use as ridgecaps.

Install corner trim, chicken door and chicken ramp. If you have an outside run fasten it using the provided hooks and eyes.