-8 inch (20.3 cm) ID threaded cap; 1.25 inch (3.18 cm) ID port with pop-out plug.
-All Poly construction. High density polyethylene. Hindered amine light stabilizer, the most effective ultraviolet inhibitor. No rust, no corrosion. Takes more kicking abuse than any pigskin.
-Two drink openings are each 15 inches (38.1 cm) high, 13.3 inches (33.8 cm) wide and 8 inches (20.3 cm) deep.
-304 stainless steel bite guards.
-Incremental 10 gallon markers and top marker showing all 85 gallons. Water level easy to read through translucent tank.
-One 2 inch (5.1 cm) drain in each drink opening. Rounded corners. Complete cleanout and drainage. Four notched flanges for easy anchoring. To anchor, use our optional USA Choice Stakes. Four 14 inch x .5 inch (36 cm x 1.3 cm) cuts. Order Model PS1. For permanent installations, order optional Model 383344 stainless steel anchor package: four anchor bolts, four plates, four flat washers, four nuts (all stainless steel). Use a 250 watt cast aluminum de-icer in the trough or equivalent. Use a thermostatically controlled heater designed for use with polyethylene in the tank. Electrical supply card threads through port. Either option will work for you. The trough option, will do a better job with minimal drinking activity (less than say 7 head). Select the option that results in the easiest, most secure hookup for your particular operation.
Warning: All electrically heated waterers must be installed by a qualified electrician and must be properly grounded. Failure to follow these and other procedures could result in electrocution of human beings and animals. Read and follow instructions.