No Heat Box Stall Drinker

THE RACE IS OVER. OUR PERFORMANCE ONE BOX STALL DRINKER WINS BY SEVERAL LENGTHS For corner installations in box stalls--but can be installed outdoors as well. Stainless steel access plates. Foam filled-R value of 7.5 per inch. Model VT100 valve delivers about 2 1/2 gallons (9.5 liters) per minute. Simple water level adjustment, easy to clean. Half moon design on back corner for securing up to a 2 inch (5.1 cm) PVC tube for plumbing from above or below. Optional heater, 250 watts, 110 volts. Heating cost is minimal-less than $10.00 per heating season. We tested this unit in our own cold chamber. Our chamber can go as low as minus 30 degrees F (-34.4 degrees C). No freezing occurred at this temperature-even after 7 days!

Optional ground mount tube (Model HT10) for hookup to underground service connections and for outdoor installations. Available in light gray.

Double wall, single piece poly construction -- ALL SMOOTH!

Internal 3/4" (1.9 cm) AND external 2" (5.1 cm) drains. Drinker is very easy to clean-no disassembly for cleaning required.

BOX STALL SPECIFICATIONS

Please allow approximately 5 - 7 days before this item ships.